TRADICLAIR PR:

• Mortar used for the creation of a single layer waterproofing or decorative coatings on exterior or interior walls.
• Semi-heavy coatings that is applied by mechanical spraying.
• Allows you to create all types of finishes in 100 different colors.  examples: rake - erased - crushed rustic - gritty - cuffed.
• Allows you to use a fine and regular rake thus reducing clean-up.

Composition:

• Binding agents (white cement & natural hydraulic lime, calcic lime)
• Fillers, sand and quartz agglomerate
• Water retention agents, bonding regulators.
• Water-proof, non-light sensitive mineral pigments

Usage:

INTERIOR AND EXTERIOR WALLS

PRB TRADICLAIR is intended for:

• Exterior or interior waterproofing and/or decorative coating, on all types of habitation, tertiary or industrial constructions.
• Coatings on old buildings in good condition.
• Ornamental brick, stone or ceramic facade joints (minimum 8 mm).

APPROPRIATE MATERIALS (Type A)

• Cast concrete (DTU 23.1).
• Bond-stone or brick masonrt (DTU 20.1) mounted on thin or traditional joints.
• Cement and non-uniform under-coating (DTU26.1).
• Old masonries and other materials (contact us).

MATERIALS TO AVOID

• All gypsum (plaster) based supports.
• Paint, R.P.E.
• Directly on wood (untreated).
• Horizontal or slanted surfaces.

APPLICATION CONDITIONS

• Temperatures +5C ~ +35C
• Do not apply on: frozen or thawing surfaces that are hot or in direct sunlight, surfaces that are wet or under heavy rain and by strong winds.
• Avoid applying sustained tints (dark tones) at temperatures inferior to +8C or in heavy humidity. (Risks of efflorescence or increased carbonization)
• Take the necessary precautions to avoid all splashing or streaming of water on a freshly coated surface (<72h) in order to avoid gullying or white trails.
• During warm or windy weather, it is important to humidify the night before application in order to assure correct re-hydration and therefore ensure a homogenous hardening or the coating.
• Protect windows and door frames before spraying the coating.

APPLICATION

Mortar pump 

• Water pressure (Bars): 8 to 12
• Working pressure for paste (Bars): 18 to 24
• Hose output rate (mn): 14 to 18
• Spray nozzles (mini): 12

Manual (by hand)

• Apply spreadable mortar with trowel, with one application lightly covering over the other.  Leveling of the underoating is done by smoothing the coating with a ruler.

copyright 2007 Minerva Inc.